Home / News / Industry News (Page 8)

  • What is the robot arm of an injection molding machine?

    Manipulators can be divided into two types: basic injection manipulators and smart injection manipulators. The basic injection manipulator generally includes a fixed mode program and a teaching mode program according to the requirements of the produc...

  • Control mode of six-axis manipulator

    Periodic mode 1. The manipulator presses the left limit switch and the upper limit switch in the original position, and presses the operation button once. The manipulator starts to descend and stops automatically when it descends to the left station ...

  • Single axis robot

    Single-axis robots are also called electric sliding tables, linear modules, single-axis drives, and single-axis robots in China. Single-axis manipulators can realize multi-axis combination through different combination methods such as Cartesian coord...

  • Manipulators or Robots with Multiple Degrees of Freedom

    The industrial robot is multi-joint in the industrial field. The industrial robot is a mechanical device that automatically performs work. It is a machine that realizes various functions by its own power and control ability. It can accept the command...

  • Problems and Solutions While Using 3-Axis Robots

    The alarm warns no matter if the 3-axis robots successfully sucked the product or not, what's the reasons and solutions? Reason 1: Somewhere is leak air, the negative pressure is not set correctly. (Most Likely) Solution: Check all the air sources wh...

  • How to Install a 3-Axis Robot on Injection Molding Machine?

    1. Check if the injection machine is functioning normal: open mold, close mold, thimble out, safety door and so on. 2. (If the injection machine fixed platen already have holes, this step can be ignored) Drill holes: Close the mold before start. Put ...

  • How to Connect a 3-Axis Robot to the Injection Molding Machine?

    After the 3-axis robot is installed on injection molding machine, then we need to connect the 3-axis robot with the injection machine: 1. Connect the wires: Turn off the power of injection machine. Classify the wires and tie them together accordingly...

  • Possible problems and solutions when using 3-axis robots Part 2

    Problem: The injection machine don't lock the mold while using 3-axis robot arm automatically Reason 1: 3-axis robot arm turned off the switch of mold locking. Solution: Open and close the safety door - one time. Reason 2: 3-axis robot alarm. Solutio...

Contact Us